IMI Norgren 11-818-998 G1/4 Low-Pressure Precision Regulator with Tamper-Proof Adjustment
IMI Norgren 11-818-998 is the G1/4 low-pressure precision regulator with a 0.02 to 0.5 bar range and tamper-proof adjusting screw.
Description
Suffix 998 targets lower setpoints than the standard 100 and gauge-port 993 versions. The exposed adjustment arrangement in the source photos differs from a normal handwheel, consistent with the tamper-proof screw listed in the exact row.
Selection Notes for 11-818-998
Use the low-pressure inlet ceiling and service group when selecting this variant. A requirement below 0.5 bar should be evaluated against this model rather than by turning down a standard 4 bar or high-pressure 10 bar version.
11-818-998 Low-Pressure and Tamper-Proof Details
| Parameter | Exact model detail |
|---|---|
| Pressure range | 0.02 to 0.5 bar |
| Maximum inlet, LP group | 8 bar |
| Typical accuracy | 0.01 bar at the stated test conditions |
| Tamper-proof adjusting screw | Standard |
| Main port / weight | G1/4 / 0.64 kg |
Low-Pressure Service and Mounting Reference
| Item | Catalogue detail |
|---|---|
| Low-pressure service kit | 2787-96 |
| Panel hole | Greater than 12 mm diameter |
| Panel wall | Less than 6 mm thick |
| Body footprint in drawing | 54 mm by 54 mm |
Select the Low-Pressure Performance Plot
The low-pressure chart uses a 0.02 to 0.5 bar range and 7 bar inlet. Its performance should be read separately from the standard and high-pressure plots on the same page.
Air Quality for Fine Low-Pressure Setting
The sheet requires 5-micron filtration and oil-free compressed air. Preserve those supply conditions when assessing stable sub-bar setpoints; the model is not a substitute for a shutoff valve.
Functional Check After Replacement
After fitting the replacement, follow the equipment commissioning procedure before returning the machine to normal operation. Where applicable, test under controlled conditions and observe response, movement, signals, leakage, and connection stability. Check the installation again after its initial run to identify any adjustment that may be needed.
Product Inquiry Support
We assist customers with industrial automation spare-part enquiries, including model confirmation, replacement questions, and initial photo comparisons. If you are unsure which version is installed, you may send the complete model code and clear photos of the nameplate or component. We will use the information provided to help review the enquiry and identify details that still need confirmation.
Additional information
| Model | 11-818-998 |
|---|---|
| Function | Low-pressure precision regulator |
| Main port | G1/4 |
| Outlet range | 0.02 to 0.5 bar |
| Adjustment | Tamper-proof adjusting screw, standard |









