IMI Norgren 11-818-998 G1/4 Low-Pressure Precision Regulator with Tamper-Proof Adjustment

IMI Norgren 11-818-998 is the G1/4 low-pressure precision regulator with a 0.02 to 0.5 bar range and tamper-proof adjusting screw.

Request a Quote

SKU: 11-818-998 Category: Tags: , Brand:

Description

Suffix 998 targets lower setpoints than the standard 100 and gauge-port 993 versions. The exposed adjustment arrangement in the source photos differs from a normal handwheel, consistent with the tamper-proof screw listed in the exact row.

Request a Quote

Selection Notes for 11-818-998

Use the low-pressure inlet ceiling and service group when selecting this variant. A requirement below 0.5 bar should be evaluated against this model rather than by turning down a standard 4 bar or high-pressure 10 bar version.

11-818-998 Low-Pressure and Tamper-Proof Details

Parameter Exact model detail
Pressure range 0.02 to 0.5 bar
Maximum inlet, LP group 8 bar
Typical accuracy 0.01 bar at the stated test conditions
Tamper-proof adjusting screw Standard
Main port / weight G1/4 / 0.64 kg

Low-Pressure Service and Mounting Reference

Item Catalogue detail
Low-pressure service kit 2787-96
Panel hole Greater than 12 mm diameter
Panel wall Less than 6 mm thick
Body footprint in drawing 54 mm by 54 mm

Select the Low-Pressure Performance Plot

The low-pressure chart uses a 0.02 to 0.5 bar range and 7 bar inlet. Its performance should be read separately from the standard and high-pressure plots on the same page.

Air Quality for Fine Low-Pressure Setting

The sheet requires 5-micron filtration and oil-free compressed air. Preserve those supply conditions when assessing stable sub-bar setpoints; the model is not a substitute for a shutoff valve.

Functional Check After Replacement

After fitting the replacement, follow the equipment commissioning procedure before returning the machine to normal operation. Where applicable, test under controlled conditions and observe response, movement, signals, leakage, and connection stability. Check the installation again after its initial run to identify any adjustment that may be needed.

Product Inquiry Support

We assist customers with industrial automation spare-part enquiries, including model confirmation, replacement questions, and initial photo comparisons. If you are unsure which version is installed, you may send the complete model code and clear photos of the nameplate or component. We will use the information provided to help review the enquiry and identify details that still need confirmation.

Additional information

Model

11-818-998

Function

Low-pressure precision regulator

Main port

G1/4

Outlet range

0.02 to 0.5 bar

Adjustment

Tamper-proof adjusting screw, standard